Use an RJ-45-to-RJ-45 BRI cable (not included) to connect the ISDN BRI port to an ISDN NT1 device. Note This step does not apply to the WIC-1SHDSL-V2, WIC-1SHDSL-V3, and HWIC-4SHDSL-E. Step 3 Connect the other end to the wall jack (RJ-11) at your site, as shown in Figure 8.įigure 8 Connecting an ADSL Card to the Wall Jack Step 2 Connect one end of the cable to the ADSL or G.SHDSL port on the card. The addition of Primary Protectors is not sufficient protection in order to connect these interfaces metallically to OSP wiring. These interfaces are designed for use as intra-building interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE, Issue 4) and require isolation from the exposed OSP cabling. The intra-building port(s) of the equipment or subassembly must not be metallically connected to interfaces that connect to the OSP or its wiring. Warning To comply with the standard for electromagnetic compatibility and safety, connect the HWIC-ADSLI-B/ST, HWIC-2SHDSL, HWIC-4SHDSL, and HWIC-4SHDSL-E interface cards only to intra-building or unexposed wiring or cable. Step 1 Confirm that the router is turned off. To connect a DSL interface card to the WAN, complete the following steps:
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |